So lads n lassies, not been on with any updates for a while with my project so I'm needing to pick some brains about my new skyline project. I have been looking out for an accident damaged/stolen recovered for my gtst project & came across this 2.5 N/A stolen recovered, usual broken window barrel & airbag dash surround & clocks ,cut alarm siren but its still running. the problem is it wont go past 2000 revs on the rev counter. Could this be a limiter because the alarm is not completely intact or throttle body ? All help greatly appreciated. Will post pics when I'm back from gym.
Welcome back mate
Afm is a good shout as it will be in limp mode
Sent from my C6603 using Tapatalk 2
Thanks Dave good to be back , I'll try it & see wot happens. Trying to get it sorted & on the road for next meet so be pretty busy for the next few weeks but it'll be great to see yours again with the yellow kit.
Is it fixable or do I need to buy a new 1, & does it have to be from an n/a to get it sorted?
Here's a few wee pics of maf. When i was looking at the how to I noticed my board is different & there's a pin on the board that's not soldered at all, will this make any difference? it's the third pin in from the right. Also found a cut vacuum pipe behind the throttle body right where the alarm siren is mounted, they probably hit it when cutting the siren wire's.
yes its meant to be blank on the n/a and you need to block of the nitrous port as it may be drawing in non metered air
also your tps may need set from the look of that first pic
Thanks bud, put afm back on & either its goosed completely or its something else,if anyone has a spare I can check it with I'd be much obliged. How do you set the tps wouldn't know the first thing about it? Cant find a sticky on it bud.