Skyline Owners Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
919 Posts
Discussion Starter #1
hiya guys im new to the forum and skyline's to be honest just bought myself a R33 GTst and im living it! just a few things i need to know

wheres there oil presser sensor?

theres a black switch to the left of my stalk when i put it on with my lights theres an orange LED lights up above speedo? is this rear fog lamp ?

what boost should it rund stand on the gauge on pannel next to rev counter? hes took his apexi gear out so think settings will be all over.

thanks guys!!
 

·
Belgium/Netherlands Area Rep
Joined
·
2,060 Posts
oi pressure sensor is next to the oil filter on the drivers side of the engine block underneath the intake plenum

if its a fog light it will be not standard as these come without a fog light, should be easy to tell by getting out of your skyline (i know you dont want to) and take a peek at the arse end

it should run 5psi up to around 4500rpm then second stage boost 7psi
remember the boost gauge is in mm HG aka Torr , not anywhere near psi or bar

enjoy
 

·
Registered
Joined
·
733 Posts
I think the standard boost guage should go about halfway from 0 - +7 on standard high boost if it goes right to +7 believe thats about 1bar and on standard turbo that aint good!!
 
1 - 3 of 3 Posts
Top