[r33nik]

i have aquired a PIT BCU+ that i am going to fit but i have a couple of questions. Firstly i am unsure what size tubing to use as the instructions do not say but i would guess something like 6mm OD and 4mm ID, is this correct. Also do i need to tee in to the pressure line on the engine as ive heard i may not need to do this?. And finally whats the max i can run my standard low mileage series 1 turbo to as i have a seperate blitz boost guage but it reads in kg/cm3 or similar (eg same as stock gauge units).
help appreciated, especially if anyone has any fot's of there boost controllers wired in......long shot i know.

 

[r33nik]

can anyone please help with what size tube i should use when fiiting a boost controller


:attention: .....

 

[loz dog]

6mm is fine mate, as long as its a tight fit!

 

[r33nik]

ok thanks for that

 

[r33nik]

is anyone else able to answer my other questions please....