Skyline Owners Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
857 Posts
Discussion Starter · #1 · (Edited)
I'm watching a set of alloys on eBay,they are off a rx7
18x8.5 et 35,seller didn't list pcd so I emailed him to check
what's stamped on the inside of the wheel,he said it reads 5x114
and 5x120? Will these fit?

This is his email reply, Hi, On the inside of the wheel is:- 5x114 690kg and 5x120 63kg Regards
 

·
516ATF and RWD......Nutter!!
Joined
·
1,685 Posts
Should be fine....they must be multi-holed and multi fitment.....ir more than 5 holes at different widths.
 

·
516ATF and RWD......Nutter!!
Joined
·
1,685 Posts
Seems impossible for them to have different pcds unless they are multi-fitment ie multi holed.
 

·
516ATF and RWD......Nutter!!
Joined
·
1,685 Posts
If they did fit the RX7 ok, they'll fit the Skyline fine.

That weight is the corneer weight each wheel can take so 63kg would be a VERY small car :D
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top