[Wile E Coyote]

I'm hoping someone has one this themselves before . I need some ideas on how to keep my pillar mount up . All three gauges are wire up ready to go but
need to keep the pillar mount up somehow . any ideas welcome

 

[General Banter]

Stupid as it sounds, mine is held up with 2 screws directly into the pillar.

 

[thescotsman]

Screws are probably the best option. Using anything "sticky" will just fall off with heat and vibration after a while. At least with screws if it starts to rattle/vibrate you can always tighten it in again.

 

[Wile E Coyote]

oh well . I'll have to buy me some screws then . Dont need it falling down while at Santa Pod doing the 1/4mile . thanx chaps

 

[General Banter]

The only other option you have if you don't like screws: The double sided adhesive strips used for number plates, they're strong little buggers them.

 

[Wile E Coyote]

I bought some real good double sided tape before coming to work . Ultra strong hold . Given it a try and waiting to see if it comes loose . hope not .

 

[General Banter]

Just re-read your first post, 3 gauges might be a little heavy for tape etc.

Screws methinks

 

[Wile E Coyote]

Me thinks you're all right . Screws it will have to be