[teck_boy2002]

Hi

I have a Blitz Oil Temp Gauge and was looking were it was plumped into and found it was not?

It was just cable tied down by the sump????

So I bought a sandwich plate from driftworks (very good very quick) and I set about plumming it in only to find the sensor had no tread.

See pic

Is there anything I'm missing here i.e. cab I get a replacement thread or do I have to replace the whole sensor.

 

[lmfracing]

Can you take a picture of the opposite side ?

 

[teck_boy2002]

I have this one which is a bit on the over exposed side

 

[ChrisC]

It looks like it has snapped to me.

 

[teck_boy2002]

Yea Thats what I thought,

Do you if I can replace it or do I have to get a whole new sensor with the wiring!!!!!!!!

 

[ChrisC]

Just looked at it again, it is def snapped!
Not sure about a replacement though, give rising sun a ring they will advise better.

 

[teck_boy2002]

Will do Thanks l