Skyline Owners Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
2,148 Posts
Discussion Starter #1
A simple question for all GTS-T owners with a Power FC fitted.

What sort of levels of knock do you detect??
 

·
Registered
Joined
·
2,148 Posts
Discussion Starter #4
cheers Richard.

I got 60 on mine last night :( but that was only right at the top of the rev range. up to about 6 1/2 it only read about 25.

better be booking some setting up time with someone then.:rolleyes:
 

·
Ut oh
Joined
·
3,796 Posts
I did a 30 min drive on the standard map on mine and it sounds about the same as your getting never went over 35 until high rpm/load when it would shoot upto about 60-70....just saving up for some mapping as well now..:)
 

·
M's Factory
Joined
·
5,240 Posts
around 60 and above i would think about looking into it. Ie. what fuel your running or are you running an additive.

Safe Levels of knock on a PowerFC I would personally look at anything under 50 being ok, as long as it doesnt stay up at the higher levels for extended periods of time.
 

·
2.8 HKSステップ3 、
Joined
·
3,072 Posts
Most I ever see on my hand controller is 35 at revs up to 8K.. and I always have the controller on peak read so at the end of a blast I know if I hurt it or not...
 

·
Registered
Joined
·
132 Posts
Knock

60 and above is DANGEROUS!

Save up for mapping? You maybe saving for a new engine

Luke
 

·
M's Factory
Joined
·
5,240 Posts
my sentiments exactly.
 

·
2.8 HKSステップ3 、
Joined
·
3,072 Posts
Rod Bell sets the knock limit on the PFC to 60..
 
1 - 10 of 10 Posts
Top