Skyline Owners Forum banner
1 - 15 of 15 Posts

·
... is modifying the driver
Joined
·
7,524 Posts
as said its shows the oil pressure

should read around 6 on startup and cold and then head down to around 4 when driving and the a little lower when idiling (as it shows in your pic)
 

·
tdi power
Joined
·
13,297 Posts
if it was a oil level then it would not have a measurement of pressure on
 

·
Seasoned member
Joined
·
563 Posts
According to the manual (in kg/cm2 same as the dash gauge) they are:-

RB20E is 1.0 at idle, [email protected] and [email protected]
RB25DE is 1.0 at idle, [email protected] and [email protected]
RB25DET is 1.0 at idle, [email protected] and [email protected]
RB26DETT is 1.5 at idle, [email protected] and [email protected]
good info that. Ive always wondered what it should be. Are these minimum pressures or ballpark?
Ross, if your light is coming on get it checked out asap. The gauge isnt accurate but i would use it as indicative of a problem
 

·
Registered
Joined
·
1,044 Posts
if you do your walk round checks... tyre tread, lights, water & OIL you wouldnt have to worry bout this gauge... unless your oil pump goes. dont rely on this for checking your oil. do it yourself.. daily!
 

·
bla
Joined
·
17,374 Posts
Its also common for the oil pressure sender unit (operates your gauge) to fail. So if its really low, there's a good chance it could be that... Hopefully, lol..

As said there not accurate anyway so good excuse to get some Uprated gauges...
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top