Skyline Owners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
I've been searching around for some answers but not been able to find anything specific enough, so asking for some help please!

I've just dropped a spec 1 RB25DET into my R32, using the RB20 loom and RB25 ECU. I've got it running on 4, had a listen to it and injectors 3 and 4 don't seem to be firing?

Anybody had this issue or have any ideas what it might be?

Any help appreciated!

Cheers
Si
 

·
Registered
Joined
·
227 Posts
I'm not certain but of the top of my head, I think injectors 3 and 4 need to be switched over with each other when using the rb25 ecu.
On my own conversion I used the rb20ecu so I didn't need to do this but I do remember reading this somewhere. Think it was on the SAU site possibly but can't remember for sure.

Do a bit more research and you should find this may be your problem.
 

·
Registered
Joined
·
81 Posts
Discussion Starter #3
According to the research I did it was injectors 4 and 6 (pins 112 and 114 on the ECU or something?) so I have done that, also tried it with the wires switched back the other way...

I hate wiring!
 
1 - 4 of 4 Posts
Top