Skyline Owners Forum banner

RWD + FWD 0-60 + Final big lap times

3K views 21 replies 19 participants last post by  moonshine 
#1 ·
Ok guys can everyone that attended yesterday post your 0-60 and final big lap times if you were driving a RWD or FWD car.

Only post results no general chat please.
 
#2 · (Edited)
My 0-60 was 5.9 and final lap time 1.39

Bit crap 0-60 as done a 5.0 at trax

My good bit was top speed which was 103.2 which i didn't think was bad as i was on budget tyres and 2 up.

Would of liked a better time on the final handling track but once i'd put the worst ever flat spots on my front tyres from the tops speed runs it was game over lol
 
#6 ·
ermmmm


0-60 5.8 seconds

never got any more as lunched my gearbox so had a 350 mile drive home with hope that it didnt fail completely :(
 
#7 ·
R33 GTST - Car 14

0-60mph - 6.2 (with a passenger lol)
Top Speed - 96.2mph (with a passenger, ended up flat spotting my tyres as well Bruce :rofl:)
Short morning track - 1:16
Technical Handling Circuit - I didnt get a time did one run but front tyres were rubbing and didnt want to push it and wreck the tyres.
Full Circuit - 1:41 (with a massive sidewways moment on the final bend, only did 1 lap)

All my times were with a passenger.
 
#9 ·
ive got photos of the timing board with all cars that did the full track- do you want them posted here bruce?

R33 GTST #6

0-60 5.6 Secs (3 times)
Top Speed 101.1
Short (sprint?) Track 1.14
Technical Track 47.6 not good run, 2nd run collected most of the cones
Full Circuit 1.39
 
#10 ·
Na its ok dogger as we don't know what number everyone was.
 
#12 · (Edited)
Im my gf integra type R
0-60 lol 6.7
just the cones 32sec
top speed 96.4
the first large lap 1.12secs
And full lap 1,31secs. Also in jasons focus RS i did full lap in 1,33secs
 
#14 ·
200sx s14a

0-60 6.5
morning lap..(slight drifting) 1,20
top speed 87mph

and fooked up on final lap...sped past entrance to handling so think i got 1.48
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top