[Neal]

http://cgi.ebay.com/Auto-Meter-Carb...1568930QQihZ016QQcategoryZ88433QQcmdZViewItem

how hard are these to wire up?

how do you set or find the optimum shifting RPM do you need to get it on the rollers to find that out?

also do you need to wire the tacho upto your speedo for the revs feed????

cheers guys .

 

[Japtastic]

I'm sure I've seen a FAQ either on here or on the NZ or OZ forums, I think the pin outs for ECU are on my site in my sig as well.

 

[Japtastic]

Ha I knew I had something somewhere Here are the instructions for the Apexi unit which gives a good diagram with the pin outs.

Page 24 ECU diagram N4-c

http://www.solve-it.org/skyline/apexi rev speed meter.pdf

 

[Neal]

cheers dude, found out its Pin 7

 

[SARU]

dont remove the yellow rubber cap of the shift light or you'll be blinded

 

[Bruce-m]

To find out your perfect shift point you need to put it on a rolling road find your peak BHP point then shift 1000rpm after it.

 

[Neal]

Cheers Bruce!